توضیحات
- XC3S50 (Xilinx-Spartan3 FPGA) + XCF02S (FLASH) header board
- XC95144 (Xilinx CPLD) header board
- 24 x LED, HEX display, dot-matrix and 4-digit multiplex 7-segment display
- 16×2 character LCD + 128×64 graphical LCD
- Stepper motor and DC motor with shafted encoder sensor
- Equipped by temperature, opto, humidity and natural gas sensors
- IrDA receiver and transmitter
- HM-T & HM-R receiver and transmitter
- 8-bit analog to digital converter
- 8-bit digital to analog converter
- 8 x push-button switch, 8 x data latch switch, 4×4 keypad and MC14490 debounce circuit
- RS-232, RS-485 and USB interface
- AVR microcontroller unit
- MT8870 tone decoder
- 555 timer, 5v buzzer and speaker
- Reading and writing into the EEPROM with SPI and I2C protocols
- 7414 low frequency square wave oscillator
Power supply and bread board
- Implementation the basic logical gates with 2 and 3 inputs
- Implementation the comparative and arithmetic operators
- Implementation the half adder and full adder
- Implementation the decoder and encoder
- Implementation the multiplexer and demultiplexer
- Implementation the bit parity generator
- Implementation the basic flip-flops with preset and clear inputs
- Implementation the up, down, ring and Johnson counter
- Implementation the different shift registers
- Setting up the 7-segment and HEX display
- Setting up the dot-matrix display
- Setting up the 4×4 keypad
- Remove the bounces of push button switches using MC14490
- Setting up the stepper motor
- Setting up the DC motor
- Setting up the ADC circuit based on ADC0809
- Setting up the DAC circuit based on DAC0800
- Interface to computer using RS-232 converter and serial port
- Wireless transmission of coded data using HM-T and HM-R transmitter/receiver
- Wireless transmission of coded data using infrared transmitter and receiver
Decode the tone signals using MT8870
نقد و بررسیها
هنوز بررسیای ثبت نشده است.